STEP 1 - PREPARATION

With cap on, forcefully turn the WHITE PART of the pen ONE FULL TURN (360° turn) in the direction of the arrow until you hear a loud click. Once you perform this step for first use, you do not need to repeat it ever again.

STEP 2 - PROTECT

Pop out the protective foam SkinShield™ from sheet. Remove and discard the center and paper backing from the foam SkinShield™. Apply the adhesive side of the foam SkinShield® around the skin tag to protect healthy skin. Use the slit in the skin shield to tighten the ring shape and snugly fit around the base of your skin tag.

STEP 3 - ACTIVATE

Place Compound W Nitro Freeze® Skin Tag Remover upright on a table, with the clear cap facing down. Hold the device with a steady grip. With the other hand, push the white pen downwards continuously until you hear exactly 2 seconds of hissing. Pushing for longer will waste useful doses. Pushing it for a shorter time reduces the freeze effect.

STEP 4 – REMOVE CAP

Remove the clear cap. The applicator tip should have a frosty appearance. Immediately proceed to Step 5. If there is no frosty appearance, replace the cap and repeat step 3.

STEP 5 - TREAT

Start the timer or use a clock to accurately time your treatment. Apply the applicator tip continuously for 20 seconds. Do not apply for longer than 20 seconds. Note: It is normal to feel an aching, stinging sensation during treatment and for a short time afterwards.

STEP 6 – STORAGE & NEXT USE

Wait at least two (2) minutes after use, then remove and dispose of the applicator tip from the pen and protective foam shield. DO NOT reuse applicator tip. Insert a new applicator tip into the pen and replace the cap. The pen is now ready for future use. Store in refrigerator and use remaining doses within 6 weeks of first use.

STEP 7 – MONITOR FOR 2 WEEKS

Skin tags may be removed in as few as 1 treatment. If the skin tag has not fallen off in 2 weeks, you may treat the skin tag again, up to a total of 3 treatment cycles. Follow steps 2 – 7 to retreat if needed. If the skin tag persists after 3 treatment cycles, stop using the product and talk to a doctor.

Canister contains dimethyl ether and propane.

KEEP OUT OF REACH OF CHILDREN

DO NOT TOUCH THE SURFACE OF THE COOLED APPLICATOR TIP. This can

result in freezing healthy skin.

CONTENTS UNDER PRESSURE. Never pierce or burn, even after use – the device is under high pressure and cannot be opened. Protect from sunlight and do not expose to temperatures above 122°F (50°C) before first use. Store at room temperature away from heat. After first use, store in the refrigerator. Nitrous oxide is a non-toxic, non-flammable gas, but it will support combustion in case of fire. Keep away from flames or materials that burn easily. Do not smoke or use near open flame.

• AVOID CONTACT WITH EYES. Contact with eyes may cause blindness. Do not rub or touch eyes if Compound W Nitro Freeze ® Skin Tag Remover has been applied to hands. If product gets into eyes, flush with water for 15 minutes and get medical help right away.

• AVOID INHALING AND USE ONLY IN WELL-VENTILATED AREAS. Breathing the

contents is hazardous – symptoms can include feeling dizzy or confused and headache.

• DO NOT EAT. Contents are toxic and may cause serious internal damage. If eaten by accident, get medical help or contact a poison control center immediately.

• FOR EXTERNAL USE ONLY.

• USE ONLY AS DIRECTED. Misuse of Compound W Nitro Freeze ® Skin Tag Remover may result in burns and permanent scarring of healthy tissue or blindness. Failure to follow instructions may result in serious injury or harm.